Skip to content

Sourcing motor capacitors for pumps, fans and HVAC

Prepare a sourcing list for a Chinese motor capacitor supplier. Match CBB60, CBB61, CBB65 or CD60 to the circuit, connections and installed fit.

CBB60 capacitor beside a pump motor at an industrial assembly workbench.

When sourcing motor capacitors from China, give the supplier one line for each capacitor position on the equipment drawing. A pump can have a run capacitor and a separate start capacitor. An air conditioner can use a single-run part or call for two capacitance sections in one can. Put the circuit duty and the approved part reference on the list before asking for a price.

Water pumps with a cylindrical run capacitor

If the pump motor specifies a wired 35 µF, 450 VAC run capacitor, the photographed HAN XING CBB60 is one reference to discuss. For the actual order, read the motor documentation and check the case diameter, body height and fixing method. A stud extends below the case. The cable bend and connector need room above or beside it.

Use separate fields for the capacitor’s rated voltage from the approved specification and the supply voltage on the motor nameplate. If the old capacitor label is unreadable, check the motor parts list or drawing before asking for a replacement.

Fans and blowers need the right connection

The CBB61 blade-terminal samples show 4.5 µF, 5 µF and 6 µF as separate parts at 450 VAC. If your fan calls for 5 µF, use that value and confirm the terminal spacing, mounting point and cover clearance. For a wire-lead version, send the harness drawing with the finished wire length and connector type.

If the fan’s wiring harness changes, mark the new lead length or connector on the drawing. Keep the approved electrical ratings on that drawing or on the datasheet it references. The supplier can then quote the change for the specified part, and your assembly team can check the sample in the fan housing.

CBB61 leads and mounting lug

The wire exit and lug on these samples are useful details to show on a fan assembly drawing.

Single and dual run capacitors for HVAC

Read each capacitance section on the equipment diagram. The P029 CBB65 sample has one value, 20 µF at 450 VAC. Sample P034 is marked 50+5 µF at 450 VAC. For a dual-run enquiry, copy both values to the line item and identify the terminal groups from the approved drawing. Include the space needed for the fitted connectors above the can.

P029 single-run configuration

The 20 µF label refers to one capacitance section.

P034 dual-run configuration

The 50+5 µF marking gives the two section values on this sample.

Specify the CD60 starting duty

Check the switching arrangement when a pump or compressor has a separate starting circuit. A CD60 is an electrolytic start capacitor. The circuit must disconnect it after startup. For equipment that can restart frequently, request the allowed time under voltage and the minimum rest interval for the specific part. Confirm enclosure temperature and terminal fit on the same proposal.

List each capacitor position in the quote request

Identify the reference currently approved for each position and place any proposed substitute on its own line. Add the equipment model, electrical ratings, drawing revision and an annual or first-order quantity where you have one. Specify which dimensions the supplier can change and which the assembly fixes.

If a supplier proposes a different connector, ask its engineer to mark that change on the drawing. Check the sample in the assembly before adding it to the approved parts list. For a required test or certificate, tell the supplier which model needs the document and where the equipment will be sold.

Send your equipment requirements

Include the motor model, capacitor label or approved drawing, quantity by configuration and delivery destination.

  • Equipment model and capacitor position
  • Capacitance, rated AC voltage and duty
  • Drawing or label, connection, quantity and destination